AutoCAD OFFSET COMMAND ||1_CMD_VIDEO ||
Hai Friends.
Welcome To UniquE CAD DesigN.
This Channel's aim to give a Unique tips on autocad, to improve your working performance in autocad drafting and use autocad software very effectively to give a Adequate output in autocad drafting.
_______________________________________
OFFSET (Command)
Creates concentric circles, parallel lines, and parallel curves.
Find
You can offset an object at a specified distance or through a point. After you offset objects, you can trim and extend them as an efficient method to create drawings containing many parallel lines and curves.
The OFFSET command repeats for convenience. To exit the command, press Enter.
The following prompts are displayed.
Offset Distance
Creates an object at a specified distance from an existing object.
Exit
Exits the OFFSET command.
Multiple
Enters the Multiple offset mode, which repeats the offset operation using the current offset distance.
Undo
Reverses the previous offset.
Through
Creates an object passing through a specified point.
Note: For best results when you offset a polyline with corners, specify the through point near the midpoint of a line segment, not near a corner.
Exit
Multiple
Undo
Erase
Erases the source object after it is offset.
Layer
Determines whether offset objects are created on the current layer or on the layer of the source object.
_______________________________________
Thanks & Regards.
Harish M
UniquE CAD DesigN
#1_CMD_VIDEO_AutoCAD_DIVIDE_Command
Смотрите видео AutoCAD OFFSET COMMAND ||1_CMD_VIDEO || онлайн без регистрации, длительностью часов минут секунд в хорошем качестве. Это видео добавил пользователь UniquE CAD DesigN 11 Ноябрь 2020, не забудьте поделиться им ссылкой с друзьями и знакомыми, на нашем сайте его посмотрели 1,111 раз и оно понравилось 12 людям.