Guitars in Fusion 360 | Part 6 - Final Touches - Pickups, Knobs, and Tuners

Published: 05 June 2021
on channel: Austin Shaner

4,113

116

This is the final episode of my how to build a guitar in Fusion 360 series! In this episode we cover the pickup slots, control cavity, knobs, tuners, switches, and installed all remaining hardware to finish the design.

Thank you all so much for investing your time into this series with me. I seriously learned a lot, and hope we all came away a little better at designing guitars than we were before.

Check out my other video titled "What's next for this channel?" to hear about where this channel will be headed in the future.

If you' enjoyed this series, please like, comment, and subscribe so you won't miss future projects! Thank you!

Part 1: Introduction & First Sketches
   • Guitars in Fusion 360  |  Part 1 - In...

Part 2: First Extrusions & Lofting Basics
   • Guitars in Fusion 360 | Part 2 - Firs...

Part 3: Shaping the Body and Neck Transition
   • Guitars in Fusion 360 | Part 3 - Shap...

Part 4: Headstock Transition
   • Guitars in Fusion 360 | Part 4 - The ...

Part 5: Fretboard, Nut, and Bridge
   • Guitars in Fusion 360 | Part 5 - Fret...

#Guitar #Fusion360 #DIY

Watch video Guitars in Fusion 360 | Part 6 - Final Touches - Pickups, Knobs, and Tuners online without registration, duration hours minute second in high quality. This video was added by user Austin Shaner 05 June 2021, don't forget to share it with your friends and acquaintances, it has been viewed on our site 4,11 once and liked it 11 people.