Guitars in Fusion 360 | Part 6 - Final Touches - Pickups, Knobs, and Tuners

Опубликовано: 05 Июнь 2021
на канале: Austin Shaner

4,113

116

This is the final episode of my how to build a guitar in Fusion 360 series! In this episode we cover the pickup slots, control cavity, knobs, tuners, switches, and installed all remaining hardware to finish the design.

Thank you all so much for investing your time into this series with me. I seriously learned a lot, and hope we all came away a little better at designing guitars than we were before.

Check out my other video titled "What's next for this channel?" to hear about where this channel will be headed in the future.

If you' enjoyed this series, please like, comment, and subscribe so you won't miss future projects! Thank you!

Part 1: Introduction & First Sketches
   • Guitars in Fusion 360  |  Part 1 - In...

Part 2: First Extrusions & Lofting Basics
   • Guitars in Fusion 360 | Part 2 - Firs...

Part 3: Shaping the Body and Neck Transition
   • Guitars in Fusion 360 | Part 3 - Shap...

Part 4: Headstock Transition
   • Guitars in Fusion 360 | Part 4 - The ...

Part 5: Fretboard, Nut, and Bridge
   • Guitars in Fusion 360 | Part 5 - Fret...

#Guitar #Fusion360 #DIY

Смотрите видео Guitars in Fusion 360 | Part 6 - Final Touches - Pickups, Knobs, and Tuners онлайн без регистрации, длительностью часов минут секунд в хорошем качестве. Это видео добавил пользователь Austin Shaner 05 Июнь 2021, не забудьте поделиться им ссылкой с друзьями и знакомыми, на нашем сайте его посмотрели 4,113 раз и оно понравилось 116 людям.

1,651