Microwave Diode Sampler for PLL

Опубликовано: 10 Январь 2022
на канале: All Electronics Channel

7,816

358

In this video, Gregory explains the working principles of a Microwave Diode Sampler used to downconvert the VCO signal in for a PLL design.

The 3.33GHz input signal is downconverted to a 12MHz IF, using a low-frequency LO of ~100MHz.

The diode sampler works on the time-domain, sub-sampling the microwave signal, thus aliasing the signal to a much lower IF. The sampling action is performed by a Schottky diode-bridge and a Step Recovery Diode pulse generator.

This design is part of the 10GHz signal source we are designing on the channel, and will be used in the phase-detector of the PLL.

Here you can see the sampler constructed working:
   • 10GHz Microwave Source - project upda...

Learn more about the 10GHz signal source project:
   • 10GHz Microwave Signal Source

00:25 - Introduction
03:00 - Working principle
06:52 - Circuit diagram
13:30 - Step Recovery Diode pulse generator

The full schematic of this sampler can be downloaded on the Patreon page.
  / allelectronics

Смотрите видео Microwave Diode Sampler for PLL онлайн без регистрации, длительностью часов минут секунд в хорошем качестве. Это видео добавил пользователь All Electronics Channel 10 Январь 2022, не забудьте поделиться им ссылкой с друзьями и знакомыми, на нашем сайте его посмотрели 7,81 раз и оно понравилось 35 людям.