OpenVPN site-to-site on Edgerouter (Static Routing)
In this video, I go over how to configure static routes between the different VPN end-point networks. This is a very quick and easy way to make routing work over the tunnel, but it will require more work in the long run if you plan on having multiple tunnels.
Below are the configuration commands for static routing.
set protocols static interface-route "destination network and mask" next-hop-interface vtun0
This is the only line of command needed to enable a static route. Put this command on both routers with the destination network address swapped (Router 1 to Router 2's network and Router 2 to Router 1's network).
Смотрите видео OpenVPN site-to-site on Edgerouter (Static Routing) онлайн без регистрации, длительностью часов минут секунд в хорошем качестве. Это видео добавил пользователь Toasty Answers 09 Февраль 2019, не забудьте поделиться им ссылкой с друзьями и знакомыми, на нашем сайте его посмотрели 4,44 раз и оно понравилось 4 людям.