How to make the AT9S Pro transmitter work with 12 channels receiver?
Why the servo is shaking violently and out of control when binding to 12 channels receiver?
One tip to fix it!
AT9S Pro is 10/12 channel transmitter.
Only need you change the transmitter channel to the same as the receiver.
For example, when you bind to 12CH receiver, you should change the transmitter channel to 12CH in the basic menu.
And when you bind to a 10CH receiver, you should change the transmitter channel to 10CH.
Connect and bind the 12CH receiver with AT9S Pro transmitter
Enter the SERVO page and check the channel-it’s 10CH
Enter the system function of the basic menu
Change channel 10 to channel 12
Enter the SERVO page and check the channel again-it shows 12 channels now
Connect and bind the 10CH receiver R9DS with AT9S Pro transmitter
Toggle the joystick, the servo is very unstable and out of control
Back to system function of the basic menu again
and change the channel to 10CH
Toggle the joystick again, the servo is work as normal
This is the reason why we need change the transmitter’s channel when working with different receiver.
Product Introduction on Official Website:
AT9S Pro: http://radiolink.com/at9spro
Buying link:
AT9S Pro: http://radiolink.com/at9spro_where_to...
10CH receiver:
R9DS: http://radiolink.com/r9ds_where_to_buy
R6DS: http://radiolink.com/r6ds_where_to_buy
R6DSM: http://radiolink.com/r6dsm_where_to_buy
12CH receiver:
R12DS: http://radiolink.com/r12ds_where_to_buy
R12DSM: http://radiolink.com/r12dsm_where_to_buy
You can send mails to [email protected] if you have any questions during using our products. #tbscrossfire#crossfiretransmitter#minipix#at9spro#radiolink
Смотрите видео How to make the AT9S Pro transmitter work with 12 channels receiver? онлайн без регистрации, длительностью часов минут секунд в хорошем качестве. Это видео добавил пользователь RadioLink 12 Январь 2022, не забудьте поделиться им ссылкой с друзьями и знакомыми, на нашем сайте его посмотрели 9,691 раз и оно понравилось 61 людям.