3D Printed Car Belt | Will It Run?
I don't know why the thought occurred to me, but I had to know if my car engine would run on a 3D printed serpentine belt. I modeled my serpentine belt in Fusion 360 and then printed it out on it's side with flexible filament.
The end result was surprisingly strong but not very pretty. I think all of the inaccuracies in the print led to it jumping around on the pulley. This belt was used to drive the alternator and water pump, so even if it fails it won't be catastrophic for the engine...hopefully.
LEARN FUSION 360 - For Hobbyist and Woodworkers:
$30 Off Coupon -
http://www.learnfusion360.com/courses...
3D Printer Used - http://amzn.to/2omfen8
Filament Used - http://amzn.to/2nHJgz5
*affiliate link
Sign up for monthly income, expenses, and net worth reports!
http://newsletter.mikeandlauren.com
Help us make these videos:
/ mikeandlauren
Twitter - / mikeandlauren
Instagram - / lauren_moyer
Facebook - / mikeandlaurentv
Check out our blog:
http://www.mikeandlauren.com
Смотрите видео 3D Printed Car Belt | Will It Run? онлайн без регистрации, длительностью часов минут секунд в хорошем качестве. Это видео добавил пользователь Mike and Lauren 05 Март 2017, не забудьте поделиться им ссылкой с друзьями и знакомыми, на нашем сайте его посмотрели 411,122 раз и оно понравилось 3.6 тысяч людям.