Making A Toolmakers Mill Vise - Machining The Vise (Part 1)
Link To Part 2 - Heat Treating: • Case Hardening And Heat Treatment - M...
G'day everyone,
In this project series I will be attempting to make a toolmakers vise to replace the big 4 inch import vise. I will be making it from scratch using 75 x 25 mild steel. In this video I will be machining the vise body, fixed jaw, moving jaw and the clamping system. In the next videos I will be heat treating and grinding the vise into tolerance. I hope you enjoy the new video series.
Timestamps
0:00 - Project Intro
1:30 - Cleaning Up And Facing The Base And Fixed jaw
3:07 - Cutting The Keyway
4:01 - Drilling, Counterboring And Tapping The Mounting Holes
5:47 - Deep Hole Drilling
6:44 - Machining The Centre Slot And Bottom Cavity
9:10 - Machining The Side Step Down
10:10 - Machining The Slot At An Angle Using A DIY Tilt Vise
11:36 - Machining The Moving Jaw
14:55 - Machining The Clamping System
18:04 - Next Problem: Hardening Mild Steel
#machining #DIY #VISEBUILD
Смотрите видео Making A Toolmakers Mill Vise - Machining The Vise (Part 1) онлайн без регистрации, длительностью часов минут секунд в хорошем качестве. Это видео добавил пользователь Artisan Makes 27 Август 2022, не забудьте поделиться им ссылкой с друзьями и знакомыми, на нашем сайте его посмотрели 234,094 раз и оно понравилось 4.4 тысяч людям.