Making A Toolmakers Mill Vise - Machining The Vise (Part 1)
Link To Part 2 - Heat Treating: • Case Hardening And Heat Treatment - M...
G'day everyone,
In this project series I will be attempting to make a toolmakers vise to replace the big 4 inch import vise. I will be making it from scratch using 75 x 25 mild steel. In this video I will be machining the vise body, fixed jaw, moving jaw and the clamping system. In the next videos I will be heat treating and grinding the vise into tolerance. I hope you enjoy the new video series.
Timestamps
0:00 - Project Intro
1:30 - Cleaning Up And Facing The Base And Fixed jaw
3:07 - Cutting The Keyway
4:01 - Drilling, Counterboring And Tapping The Mounting Holes
5:47 - Deep Hole Drilling
6:44 - Machining The Centre Slot And Bottom Cavity
9:10 - Machining The Side Step Down
10:10 - Machining The Slot At An Angle Using A DIY Tilt Vise
11:36 - Machining The Moving Jaw
14:55 - Machining The Clamping System
18:04 - Next Problem: Hardening Mild Steel
#machining #DIY #VISEBUILD
Watch video Making A Toolmakers Mill Vise - Machining The Vise (Part 1) online without registration, duration hours minute second in high quality. This video was added by user Artisan Makes 27 August 2022, don't forget to share it with your friends and acquaintances, it has been viewed on our site 234,094 once and liked it 4.4 thousand people.