How to track route with using object track command in HSRP protocol - part 6

Опубликовано: 29 Август 2022
на канале: Cisco Network - AZ

330

#How to track route with using object track command and HSRP
In order to track any route with using object track command you can use following commands-
Go to config mode of the router -
object 20 ip route 8.8.8.8 255.255.255.255 reachability
delay up 5 down 6
exit

Note - you can use any of the object number and make sure before track any route make sure that route must be available in router's routing table

How to call object track number in HSRP configuration to decrement in priority -

Go to interface mode of the router -
int g2/0
standby 2 track 20 decrement 40
exit

for verification you can use the following commands -
#show track (for object track)
#show run | section track
#show standby all
#show standby brief

Смотрите видео How to track route with using object track command in HSRP protocol - part 6 онлайн без регистрации, длительностью часов минут секунд в хорошем качестве. Это видео добавил пользователь Cisco Network - AZ 29 Август 2022, не забудьте поделиться им ссылкой с друзьями и знакомыми, на нашем сайте его посмотрели 330 раз и оно понравилось 3 людям.

1,011