Mike Makes an Adjustable Height Workbench (Lifting Mechanism)
I'm building an adjustable height workbench but I needed a lifting mechanism to raise and lower the middle shelf. I decided to use 2 trailer jacks (Curt 28204) and 1/2" rod to connect them. This same design could be used to make an adjustable height desk.
No one part of this project was difficult, but everything took a little longer than expected. The end result seems very sturdy and is a good foundation to build a workbench/out feed table from.
Parts (Amazon Affiliate)
Bearing - http://amzn.to/29RcfrE
Gear - http://amzn.to/29RbMpu
Chain - http://amzn.to/29Rc9Ap
Rod - http://amzn.to/29Rcz9M
Sign up for monthly income, expenses, and net worth reports!
http://newsletter.mikeandlauren.com
Check out our blog:
http://www.mikeandlauren.com
Follow us:
/ mikeandlauren
Смотрите видео Mike Makes an Adjustable Height Workbench (Lifting Mechanism) онлайн без регистрации, длительностью часов минут секунд в хорошем качестве. Это видео добавил пользователь Mike and Lauren 19 Июль 2015, не забудьте поделиться им ссылкой с друзьями и знакомыми, на нашем сайте его посмотрели 275,184 раз и оно понравилось 2.8 тысяч людям.