Multi-Channel ADC with STM32 using DMA and Interrupt– Multiple Analog Sensors
Learn how to use Multi Channel ADC with STM32 Microcontroller. We’ll program ADC to read multiple ADC channels of STM32 Nucleo board. This project uses DMA and Interrupt along with ADC to sample multiple sensor data. In the end, we’ll measure light intensity using LDR and variable resistor using POT as an analog sensor.
[SUPPORT]
►► Try Altium Student Lab! You get FREE access to Altium Designer and Altium 365
https://www.altium.com/in/yt/binaryup...
►► Free search engine for the best quality components from Octopart: https://octopart.com/
►► Learn about Altium 365, the electronics product design platform that unites PCB design, MCAD, data management, and teamwork: https://www.altium.com/altium-365
[RESOURCES]
►► Need Help? To Learn Embedded Systems: https://courses.binaryupdates.com
►► Single Channel ADC: • How to use ADC in STM32 Microcontroll...
[TIMESTAMPS]
00:00 Introduction
00:16 Altium Free Trial
00:47 Create new project
01:28 Configure Multi-channel ADC
03:04 Configure DMA in ADC
03:48 Configure NVIC Interrupt
04:30 Configure UART
05:04 Write code for ADC Multiple Channel
15:03 Connect LDR and POT with STM32
16:26 Upload the code on STM32 MCU
16:42 read multiple analog sensor values
18:05 outro
Смотрите видео Multi-Channel ADC with STM32 using DMA and Interrupt– Multiple Analog Sensors онлайн без регистрации, длительностью часов минут секунд в хорошем качестве. Это видео добавил пользователь BINARYUPDATES 01 Октябрь 2023, не забудьте поделиться им ссылкой с друзьями и знакомыми, на нашем сайте его посмотрели 20,499 раз и оно понравилось 303 людям.