ROOK 2020 MK2 3DP Build | Part 1
In this video, I will be building the Rook MK2 2020. I have covered the mechanical build; however, CPAP installation, wiring, and firmware installation are still pending and will be covered in the next part of the video.
Visit JLCMC for mechanical parts- https://jlcmc.com/?from=Looplinks
Rook MK2 Resource (Build Manual, STL’s and BOM etc.) - https://www.printables.com/model/7987...
Elecrow Tochscreen- https://www.elecrow.com/rc050s-hdmi-5...
Raspberry pi 4 - https://www.elecrow.com/raspberry-pi-...
Hexagon Parts Tray by @SteveBuilds
https://www.printables.com/model/1713...
Filament used -
1. Army Green PLA+
2. Beige Brown PLA+
3. Ivory White PLA+
3d Printer Used -
Flashforge Adventurer 5M Pro : https://flashforge.com/products/adven...
----------------------------------------------------------------------------------------------------------------
Music provided by TheRelaxedMovement.
Check it out here : @TheRelaxedMovement
© Henry Keate t/a TheRelaxedMovement. All Rights Reserved
#3dprinting #diy #rook
Смотрите видео ROOK 2020 MK2 3DP Build | Part 1 онлайн без регистрации, длительностью часов минут секунд в хорошем качестве. Это видео добавил пользователь LoopLinks 08 Декабрь 2024, не забудьте поделиться им ссылкой с друзьями и знакомыми, на нашем сайте его посмотрели 7,008 раз и оно понравилось 196 людям.