I 3D printed a FREE combat robot design (Plastic antweight build guide)
Team Malice of Battlebots has a bunch of free CAD for PLASTIC ANTWEIGHT combat robot designs. I downloaded, 3D printed, assembled and made instructions for you to build it to. I even included a bill of materials. I named the robot Jackalope and it is a two wheeled lifter. I made to include the fights from @betzbotz
Event stream:
https://www.youtube.com/live/bwrDt9SY...
Where to get designs:
Team Malice: https://teammalice.com/index.php/scar...
(I printed 9Volt btw)
Jair (MRCA Member): https://www.thingiverse.com/jairemia/...
Plifter: https://www.printables.com/model/4426...
Electronics:
Malenki: https://itgresa.com/product/malenki-n...
Switch: https://www.fingertechrobotics.com/pr...
RR drive motors (3mm shaft): https://repeat-robotics.com/buy/brushed/
Cheap servo w/ horn (not the one I used): https://tinyurl.com/5cwvzzjx
Servo I used (doesn't come with horn): https://itgresa.com/product/gs-5515mg...
Servo horns (if you get a servo without it): https://tinyurl.com/243espk9
Bricklink (for tires): https://www.bricklink.com/v2/catalog/...{%22iconly%22:0}
Filament used: https://overture3d.com/products/overt...
0:00 Intro
0:52 Tools
1:21 Team Malice Site
2:58 Alternative Designs
3:17 CAD
6:38 Electronics
8:01 Hardware
9:00 3D Printing
10:08 Wiring
11:14 Tires
14:40 Forks/Lifter
19:19 Zip Ties
24:29 Servo Horn/Lifter
27:21 Wire Management
33:38 Top Plates
36:21 Adjusting Servo Throw
37:44 Fights!
42:46 Final Thoughts
Смотрите видео I 3D printed a FREE combat robot design (Plastic antweight build guide) онлайн без регистрации, длительностью часов минут секунд в хорошем качестве. Это видео добавил пользователь Team Cryptid Robotics 02 Октябрь 2024, не забудьте поделиться им ссылкой с друзьями и знакомыми, на нашем сайте его посмотрели 1,539 раз и оно понравилось 42 людям.