How to make an automatic voltage regulator AVR for a portable Honda generator Elemax / sawafuji FHD
An automatic voltage regulator (AVR) is a solid state electronic device for automatically maintaining generator output terminal voltage at a set value. It will try and do this as the generator load or operating temperature changes. The AVR is part of the alternators excitation system.
a away is the same beacon and husty generator
Here we explain the generator AVR is located can be in the alternators terminal box and it could be (only on very small portable units usually) located under the alternators rear cover.
How does an AVR work?
It controls output by sensing the voltage from the generator terminals and comparing it to a stable reference. The error signal is then used to adjust the field current by increasing or decreasing the current flow to an exciter stator, which in turn will lead to a lower or higher voltage at the main stator terminals.
In this video I will try to explain how to make a simple AVR by starting from start to finish and ready to use.
Please support the content of this video in a way
✔ Like
✔ Share to other or Social media
✔ Subscribe
✔ Comments and
✔ Set Bell Notifications On
So that we can be even more excited about producing the next useful videos. especially in the world of electronics, Indonesia and the world
If you have questions and suggestions, please write in the comments room and will be replied to according to our ability.
diy automatic voltage regulator
#JNElectric #AVRGenset #GenSet
Смотрите видео How to make an automatic voltage regulator AVR for a portable Honda generator Elemax / sawafuji FHD онлайн без регистрации, длительностью часов минут секунд в хорошем качестве. Это видео добавил пользователь JN Electric 11 Апрель 2021, не забудьте поделиться им ссылкой с друзьями и знакомыми, на нашем сайте его посмотрели 35,76 раз и оно понравилось 42 людям.