Right Angle 7/16 DIN Male Crimp Connector For RG58 & LMR-195 - Perfect For DIY Installs!
https://www.showmecables.com/716-din-...
Are you looking for a quick and easy DIY installation or repair for your coax cable?
Our Right Angle 7/16 DIN Male connectors for RG58 & LMR-195 will provide a simple solution for your wiring needs.
Because this is a 2 piece connector, the pin is pre-installed to the connector housing. The only other piece to the connector is the crimp ferrule.
For this installation you will need: A coax stripper, coax cable, a soldering iron, crimp tool, and the 7/16 connector.
Keep in mind, you will want to make sure that your coax stripper, crimp tool, and connector match the coax cable that you are installing.
Start by inserting the ferrule over the outer jacket of the cable. Then, using your cable stripper, strip back the outer jacket and dielectric. The advantage of using a cable stripper is that it will strip back the jacket and dielectric at the same time.
Pull back the braided shield and Insert the connector housing onto the cable. Make sure that the center conductor reaches the well inside the base of the connector. Then solder the conductor onto the solder well
Then, slide up the ferrule to the base of the connector, folding the shield with it. Screw on the small backplate and crimp the ferrule onto the outer jacket to complete termination.
Congratulations, you have successfully installed the 7/16 DIN connector.
For all of your cable and connector needs, choose Show Me Cables
Connect with Us Online:
/ showmecables
/ showmecables https://www.showmecables.com/blog
Смотрите видео Right Angle 7/16 DIN Male Crimp Connector For RG58 & LMR-195 - Perfect For DIY Installs! онлайн без регистрации, длительностью часов минут секунд в хорошем качестве. Это видео добавил пользователь ShowMeCables 09 Декабрь 2015, не забудьте поделиться им ссылкой с друзьями и знакомыми, на нашем сайте его посмотрели 235 раз и оно понравилось 0 людям.