how to check data is sending in cisco packet tracer| send packet in cisco | Mik technical
how to check data is sending in cisco packet tracer| send packet in cisco
Open Cisco Packet Tracer and create a network topology that includes the two PCs you want to test.
Connect the PCs to a switch or a router using appropriate network cables. Make sure the connections are properly established.
Power on the PCs and wait for them to boot up.
Once the PCs are powered on, select one PC and click on it to open the Desktop tab.
In the command prompt or terminal, you can use the "ping" command to test the connectivity. The syntax for the ping command.
Execute the ping command and observe the results. If the two PCs are connected properly and have IP addresses in the same subnet, you should see responses indicating successful connectivity. If the ping command times out or shows errors, it indicates a connectivity issue.
You can also try pinging the IP address of the default gateway (router interface) connected to the PCs. This helps ensure that the PCs can communicate with the local network and beyond.
#howtochechconectivityb/tpcs
#check_data_is_send
Смотрите видео how to check data is sending in cisco packet tracer| send packet in cisco | Mik technical онлайн без регистрации, длительностью часов минут секунд в хорошем качестве. Это видео добавил пользователь MIK technical 16 Июнь 2023, не забудьте поделиться им ссылкой с друзьями и знакомыми, на нашем сайте его посмотрели 98 раз и оно понравилось 0 людям.