Building a Solid State Tesla Coil: Secondary Coil
This is the first video in the series "Building a Solid State Tesla Coil".In this video, we will build the secondary coil for my new small solid state tesla coil model "Alpha-DR mark IV", which will be capable of generating electrical discharges greater than 1.30m (~51.2") in length.
Some specs about the secondary coil:
PVC form: 102x367mm (~4x14.45"), 1.8mm (~71th) wall
Winding: 357mm (14") of 31AWG PU enamealed copper wire, ~1370 turns
DC resistance: 190 Ohms (Measured)
Inductance: 46.3mH (Measured)
Resonant frequency (with no topload): ~280kHz.
Any question? feel free to comment on.
Featured social media:
👉Instagram: @franzolielectronics
👉TikTok: @franzolielectronics
👉Facebook: Franzoli Electronics
👉Reddit: @franzolielectronics
👉Patreon: franzolielectronics
Donations:(PayPal): [email protected]
Camera: Full spectrum Lumix LX100
Audio Recorder: Zoom H1n.
#teslacoil #secondary #franzolielectronics #diy
Смотрите видео Building a Solid State Tesla Coil: Secondary Coil онлайн без регистрации, длительностью часов минут секунд в хорошем качестве. Это видео добавил пользователь Franzoli Electronics 18 Март 2024, не забудьте поделиться им ссылкой с друзьями и знакомыми, на нашем сайте его посмотрели 8,49 раз и оно понравилось 81 людям.