Edgerouter X First Time Setup
In this video, I go over how to configure an Edgerouter-X for the first time. If you don't quite know how to get your internet up and running with the ER-X just follow the steps in this video and get it running in no time.
Hardware Offload Commands: (ER-X, ER-10X, EP-R6, ER-X-SFP)
configure
set system offload hwnat enable
set system offload ipsec enable
commit
save
Hardware Offload Commands for Cavium-based devices (ER-6P, ER-4, ERLite-3, etc...). The commands are slightly different for different models. If the above commands do not take with your specific model, try these.
configure
set system offload ipv4 forwarding enable
set system offload ipv4 gre enable
set system offload ipv4 pppoe enable
set system offload ipv4 vlan enable
set system offload ipv4 bonding enable
set system offload ipv6 forwarding enable
set system offload ipv6 pppoe enable
set system offload ipv6 vlan enable
set system offload ipsec enable
commit
save
Watch video Edgerouter X First Time Setup online without registration, duration hours minute second in high quality. This video was added by user Toasty Answers 11 March 2019, don't forget to share it with your friends and acquaintances, it has been viewed on our site 306,96 once and liked it 3.9 thousand people.