Connect two networks with CISCO Router using IPv4 & IPv6 - Lab12 | Free CCNA 200-301 Lab Course
Connect two networks with CISCO Router using IPv4 & IPv6 - Lab12 | Free CCNA 200-301 Lab Course
Previous Lab11: • IPv6 Automatic Configuration - Lab11...
Next Lab13: • DHCP Server for Two Networks - Lab13 ...
0:00 Introduction
00:32 Design the Topology
02:41 Design Addressing Table
15:55 Basic Settings on CISCO Devices
17:28 Configure Router interfaces with IPv4 and IPv6 Address
20:07 Enable IPv6 Unicast-Routing
20:50 Configure Management interface(SVI) on CISCO Switch
23:05 Verify the configuration using show commands
24:07 Configure the End Devices with IPv4 and IPv6 Address
29:20 Test End-to-End Connectivity
WhatsApp: +918078212814
Visit our Website to contact us: http://techacadhelp.com/contact-us/
Follow us on
Facebook: / techacad4u
To Avail Files, join Telegram: t.me/techacadhelp
#TechAcad #CISCO #CCNA #PacketTracer #Networking
Watch video Connect two networks with CISCO Router using IPv4 & IPv6 - Lab12 | Free CCNA 200-301 Lab Course online without registration, duration hours minute second in high quality. This video was added by user Tech Acad 12 June 2021, don't forget to share it with your friends and acquaintances, it has been viewed on our site 3,969 once and liked it 50 people.