Fix Samsung Washing Machine Error 4E problem with Water Inlet and Sensor Water Level
Samsung 4E (4C) ERROR Please Read here
The 4E (4C) error indicates that the washing machine has detected a problem with the water supply.
A few solution Samsung Error 4E
Check 1 - Water flow too small
System will show error 4E, for safety and washing machine will stop and give warning 4E
Usually, after 10-15 minutes, because water supply very slow into washing machine tube. Error will show 4E.
Make sure the water inlet enough in 10-15 minutes. Or you can try, like filling the water into the tube washing machine manual.
Check 2 - the water flow is slightly clogged
Check to see if the water hose mesh filter is not block.
After 10-15 minutes, system washing machine will show error 4E and Samsung washing machine will stop working
You should clean the water hose from mesh around the filter at least twice a year to prevent build up.
Before you check no 3.
• Samsung Washing Machine Overfilling W...
Make sure you check connector caable water level sensor.
Plug and unplug again. And try turn on the washing machine.
Make sure pipe from tube to water level sensor not blok.
Such as dirt or detergent marks that clot
Check 3 - Problem with water level sensor unit.
This rare , and we get this problem.
Usually problem from pipe level sensor.
Leaking pipe level water sensor, bent pipe, clogged pipe or the pipe is broken.
Drum or tube washing machine will spin, and make vibration.
Sometime, the pipe connect tube and water level sensor pulled out until bent, or friction and leaking occur.
Bent will be block water pressure to sensor, and cannot detect water level in tube, the same.leak (maybe bitten by a mouse) or loose water sensor pipe make sensor wrong detect water level in tube. Even though the water in tube already full
Water level sensor not work properly. And send wrong signal to board, "no water inside tube" .
After 10-15 minutes. Even water overflow or full
Automatic system board will show Error 4E. And Washing Machine will stop
Make sure the water level sensor installed properly
Check 4
From Leslie Divina
Vibration from drum, can unplug pipe water level sensor
You must check small pipe connect from water level sensor, to tube mounting too. If the pipe released, plug back again, and must restart your washing machine
I hope can help
Watch video Fix Samsung Washing Machine Error 4E problem with Water Inlet and Sensor Water Level online without registration, duration hours minute second in high quality. This video was added by user Obengplus com 12 April 2019, don't forget to share it with your friends and acquaintances, it has been viewed on our site 514,705 once and liked it 2.1 thousand people.