Bode 100 Making Low Impedance Measurement using the BWIC Jig
When making a low impedance measurement, the Two Port Method is the preferred way of making low impedance measures below 1mohm. However, if you clean the contacts of the BWIC (specified at 20 mohm to 600 kohm) and PCB, and use some shielding, you can extend the measurement of the BWIC down to 1mOhms or less. Questions or comments can be sent to [email protected].
Watch video Bode 100 Making Low Impedance Measurement using the BWIC Jig online without registration, duration hours minute second in high quality. This video was added by user Robert Bolanos 04 December 2022, don't forget to share it with your friends and acquaintances, it has been viewed on our site 1,031 once and liked it 25 people.