How to make RJ45 connector, Cat6 cable connector
Making a RJ45 connector-
The process of installing the RJ-45 connector will be easier if you have plenty of exposed cable to work with.
Once you remove the outer cover, you'll see that some of the pairs of wire are twisted together (hence the name twisted-pair cable). Untwist these wires. Once all the wires have been separated, pull them backward, so you can cut off the exposed plastic core, as shown. Remove as much of this core as you can. Be careful not to accidentally cut the wires in the process.
Once you've straightened the wires, your next task is to arrange them in the order they'll be placed into the RJ-45 connector. Working from left to right, the order of the wires is:
Orange with a white stripe
Orange
Green with a white stripe
Blue
Blue with a white stripe
Green
Brown with a white stripe
Brown
When the cable is finally cut to the correct length, you should check a few things before crimping the cable. First, make sure the wires go all the way to the end of the RJ-45 connector, as shown. The easiest way to do this is to look at the end of the connector and make sure you see copper in each wire slot.
After you can crimp the cable. When you've finished crimping both cable ends, you can use a cable tester to verify that the ends were installed correctly.
Watch video How to make RJ45 connector, Cat6 cable connector online without registration, duration hours minute second in high quality. This video was added by user NetworkPeer 11 December 2021, don't forget to share it with your friends and acquaintances, it has been viewed on our site 1 once and liked it people.