Brocade ICX 6450 – Fan Modification Guide for a QUIET Switch

Published: 05 March 2019
on channel: Vicious Computers
12,269
183

The Brocade ICX 6450 is another “unicorn” switch for home labers. It has a fully featured CLI and all the major Layer 3 switching capabilities. It’s available pretty cheap on ebay so keep your eyes out for a deal.

As an enterprise switch it has top end hardware components and is capable of putting out a lot of PoE Power.

For the actual switch information check out Ruckus’s site as they bought Brocade or here is a great PDF document: https://www.flyteccomputers.com/ext/b...

The switch comes as a 24 or 48 port with and without PoE.
ICX 6450-48P : 48 Port PoE
ICX 6450-24P : 24 Port PoE
ICX 6450-24 : 24 Port No PoE
ICX 6450-48 : 48 Port No PoE

As for our modification we are using 40x40x20mm Sunon Maglev Fans.

The ones I used in the video were the Sunon KDE1204PKVX (6.8CFM) fans from Amazon: https://amzn.to/2ERbD87

I actually intended to buy the MB40201VX (10.2CFM) fans but the seller had the wrong picture so I got the wrong fans. Here is a listing for the correct fans: https://amzn.to/2HikaT6

Also good news! – I am 99% sure that CoolerGuys has already reversed the correct wires for you on the fan listed “For Cisco Routers & Switches” so that saves you the trouble.
Edit: A user tried these fans and said the pins ARE NOT in the correct order so be sure to test your switch and move the pins needed for the correct order.

In addition to the fans I used 1.25” #8 screws with a threaded nut: https://amzn.to/2XHipVA & https://amzn.to/2XHzM8r (Item# 887480037814 @ Home Depot)

Fan Pinout Information

Stock Fans Had Black, Yellow, Green wires.
BYG
Black is Ground
Yellow is 12v
Green is Sensor

New Fans Use standard Yellow, Red, Black
YRB
Yellow is Sensor
Red is 12v
Black is Ground.

So you can see the common position is the center wire on both is 12v but the colors are not the same.

What we need to do is change the Yellow and Black wires around.
BRY

Then we will have the pin out to match the factory fans.

Wire for wire matching:
Old Wire Black – New Wire Black
Old Wire Yellow – New Wire Red
Old Wire Green – New Wire Yellow


Watch video Brocade ICX 6450 – Fan Modification Guide for a QUIET Switch online without registration, duration hours minute second in high quality. This video was added by user Vicious Computers 05 March 2019, don't forget to share it with your friends and acquaintances, it has been viewed on our site 12,26 once and liked it 18 people.