How To Break In Mercury 4 Stroke Motor (Break in Procedure for 20hp, 25hp, 30hp)
In today's video I talk about how to break in Mercury 4 stroke motor as well as break in mercury 25 engine, break in mercury 30 motor and finally break in Mercury 20hp motor.
I recently purchased a new Mercury 25hp motor and according to the owners manual there is a proper Mercury break in procedure for all their outboard engines and outboard motors. The break in procedure for the Mercury 20hp, 25hp and 30hp outboard engines is as follows.
Warm up the engine at idle for 1-2 minutes.
1st hour - Vary the throttle from idle up to 50% (3500rpms). This is half throttle.
2nd hour - Vary the throttle from idle up to 75% throttle (4500rpms). This is 3/4 throttle. Every 10 minutes, do a full throttle (100%) run for one minute straight.
After the two hour break in procedure, it states for the following eight hours, do not full throttle the motor for longer than five minutes at a time.
Well everyone, I hope you enjoyed today's quick guide on how to break in Mercury 4 stroke motor as well as break in mercury outboard and break in mercury 25hp and break in mercury 30hp engine.
Hope it helps!
Watch video How To Break In Mercury 4 Stroke Motor (Break in Procedure for 20hp, 25hp, 30hp) online without registration, duration 04 minute 22 second in high hd quality. This video was added by user JMG ENTERPRISES 08 August 2024, don't forget to share it with your friends and acquaintances, it has been viewed on our site 96 once and liked it people.